Solutions to common problems of the floor washing machine: when the battery floor washing machine fails to start, first ensure whether it is powered on, because the battery floor washing machine has an overload protection system to protect the normal operation of the hardware. When the operation is abnormal, the overload protection system will automatically stop working to prevent further damage to the hardware. Try to stop the floor washing machine and start it for a period of time, When it is found that the circuit board fails, it needs to be maintained by the professional after-sales service team of the floor washer manufacturer. Do not repair it without permission.

There are many reasons for the unsatisfactory brushing effect of the floor washer. If it is possible that the pressure of the brush plate of the floor washer is insufficient, it can increase the pressure with the ground. The brush plate of the floor washer is excessively worn and has no friction with the ground. Replace the brush plate. It should be reminded that if the brush plate is not replaced in time, it will cause wear to the ground; Insufficient water in the washing machine affects the washing effect; The brush plate of the floor washer is not installed correctly; There are many foreign matters on the brush disc, which will affect the contact with the ground and seriously wear the ground. The floor washer does not discharge water, which may be due to the problem of solenoid valve or drain motor. The water absorption of the floor washer is insufficient. Check whether the scraper is excessively worn. Change the scraper on another side or replace it with a new one; Whether the scraper is close to the ground, and the scraper angle can be adjusted to achieve the ideal effect; The sewage water level in the sewage tank of the floor washer is higher than the suction pipe orifice, which may also affect the suction capacity; Check whether the suction pipe is blocked by foreign matters; Check whether the sewage tank of the floor washing vehicle is covered properly. If it is not covered properly, it will affect the suction.

The floor washer is not self-propelled. When the slope is greater than the power of self-propelled, it will not be self-propelled or large obstacles will hinder the progress; The self-propelled vehicle will also be affected if the vehicle is not in gear or the vehicle is overloaded. The brush disc does not rotate and cannot be loaded and unloaded automatically. When the brush disc of the floor washing vehicle is blocked by foreign matters, it will affect the rotation.